fortypoundhead.com

NETSTAT.exe

Primary Category = Windows Commandline

Posted On 2005-11-1 by FortyPoundHead
Keywords: Command Reference
Tags: Windows Commandline Windows
Views: 1473
Rating: / 5.00

  • 1
  • 2
  • 3
  • 4
  • 5

 

NETSTAT.exe

Display current TCP/IP network connections and protocol statistics.


syntax
NETSTAT [options] [-p protocol] [interval]
key -a Display all connections and listening ports.
-e Display Ethernet statistics. (may be combined with -s)
-n Display addresses and port numbers in numerical form.
-r Display the routing table.

-o Display the owning process ID associated with each connection.
(XP only)

-p protocol Show only connections for the protocol specified;
may be either: TCP or UDP.
Windows 2K/XP also allow: TCPv6 or UDPv6.
If used with the -s option then the following protocols
may also be specified: IP, IPv6, ICMP,or ICMPv6.

-s Display per-protocol statistics. By default, statistics are
shown for IP, ICMP, TCP and UDP.
Windows 2K/XP will also display: IPv6, ICMPv6, TCPv6 and UDPv6
The -p option may be used to specify a subset of the default.

interval Redisplay statistics, pausing interval seconds between
each display. (default=once only) Press CTRL+C to stop.

About the Author

FortyPoundHead has posted a total of 1975 articles.

You can find more information from FortyPoundHead by visiting .

Comments On This Post

No comments on this post yet!

 

Do you have a thought relating to this post? You can post your comment here. If you have an unrelated question, you can use the Q&A section to ask it.

Or you can drop a note to the administrators if you're not sure where you should post.


Your IP address is:54.163.159.27

Before you can post, you need to prove you are human. If you log in, this test goes away.