The dark secrets of loopback addresses

Posted On 2007-01-24 by FortyPoundHead
Tags: General Networking Tip 
Views: 1523

Loopback interfaces are primarily used for troubleshooting, router management and protocol enhancement. Over the next three paragraphs, I''ll explain.

First, troubleshooting can be made easier with loopback interfaces. For example, If I am configuring MY network stack with a new network, I can create a loopback address on a router and test (ping) through the network to ensure I configured the routes and access-lists correctly. There are more uses, especially when it comes to ATM interfaces and such.

Next, some administrators use loopback interfaces for SNMP management. It saves on real interfaces and can provide the same info. I''ve seen networks that utilize loopback interface exclusively for SNMP, they do this to avoid sending their real IP''s over the Internet, or at least that is what he told me. I don''t much experience with this one.

Finally, OSPF can use the loopback interfaces in determining the next feasible successor in case a router goes down. OSPF uses the lowest numerical address as the best and you can configure loopback interfaces to accomplish this goal.

Loopback interfaces are commonly configured as such:

router#(config) interface loopback0 * you can use any number you want
router#(config-int) * from here you can configure it pretty much like any other interface (ip address, shut, ect.)

There is a lot of info on the net about this, as its a pretty in depth topic. I hope this article just provides some basic info.

About the Author

FortyPoundHead has posted a total of 1974 articles.


Comments On This Post

No comments on this post yet!

Do you have a thought relating to this post? You can post your comment here. If you have an unrelated question, you can use the Q&A section to ask it.

Or you can drop a note to the administrators if you're not sure where you should post.

Your IP address is:

Before you can post, you need to prove you are human. If you log in, this test goes away.

Recent Forum Posts

Malicious IP Checker Companion Tool
dwirch posted on August 12, 2017 at about 20:24 in Site News

Job Spammer: Steve Adams
dwirch posted on August 8, 2017 at about 7:44 in Spammers

New security implemented
dwirch posted on August 8, 2017 at about 6:43 in Site News

New security implemented
dwirch posted on July 23, 2017 at about 6:58 in Site News

Fold Code Manager into main KB?
VB6Boy posted on July 22, 2017 at about 14:42 in Site News

Fold Code Manager into main KB?
dwirch posted on July 22, 2017 at about 14:41 in Site News